Penn 535 bearings???
- Thread starter louis268
- Start date
codseeker
Well-known member
try this thread louis some info on there
http://www.nesa.co.uk/forums/shore-fishing/28211-penn-reel-spares-uk.html
http://www.nesa.co.uk/forums/shore-fishing/28211-penn-reel-spares-uk.html
Hi new on here, but you can get 525 bearings from the Gateshead bearing Company, Its in Bill Quay just off the felling bypass. Hope this link works,
Gateshead Bearings Ltd
You may have to type it in your browser as i cannot find the tool to make it into a Hyperlink.
However the bearings are 6 quid a set, abec 5 rated (made in France), and the size is imperial (American reel)
(from memory so check)
OD. 3/8"
ID. 3/16"
thickness 1/8"
Speak to him on the Phone and confirm the sizes he deals with the fishing lads on a regular basis.
The tellephone number is as follows.
0191 4386969
hope this is usefull
Davey-m
Well-known member
I take it it's your spool bearings that need changing Email Charlie at this address [email protected]. He will send you an invoice to pay via PayPal.
Make sure if it's the model with the right bearing bigger that the left that you tell him incase he sends you both bearings that are the same size!
Better still use the schematics to quote the bearing part numbers.
Hope this helps.
Make sure if it's the model with the right bearing bigger that the left that you tell him incase he sends you both bearings that are the same size!
Better still use the schematics to quote the bearing part numbers.
Hope this helps.
535 not 525 Bearing size correction
535 not 525 Bearing size correction
Just noticed penn 535 bearings! Not the sizes I highlighted which were for a 525,
If you do go to Gateshead bearings for them take the reel in and he should match them...sorry for the mistake...my fault for assuming you had the same problem I had with my 525....
try the guy hes cheap local and helpful. ring him first to check if hes in the shop he does a lot of site visits and can be out.
535 not 525 Bearing size correction
Just noticed penn 535 bearings! Not the sizes I highlighted which were for a 525,
If you do go to Gateshead bearings for them take the reel in and he should match them...sorry for the mistake...my fault for assuming you had the same problem I had with my 525....
try the guy hes cheap local and helpful. ring him first to check if hes in the shop he does a lot of site visits and can be out.
